CyberData 011123x Spezifikationen PDF herunterladen (Seite 42)

Operations Guide 930370M CyberData Corporation

Installing the VoIP Indoor Intercom with Keypad (Flush-Mounted)

Parts List

2. On the Button Configuration page, you may enter values for the parameters indicated in

Ta b l e 2-11.

Table 2-11. Button Configuration Parameters

Web Page Item Description

Telephone Dial Mode

Enable Telephone Operation Select Enable Telephone Operation to put the Intercom

into Telephone Dial Mode. In Telephone Dial Mode, the

Intercom will operate like a telephone:

• To make a call in this mode, press the Call Button to go

'off-hook'. The unit will begin playing a dial tone and will

wait for keypad input.

• Dial the extension you want to reach and wait.

• Pressing the Call Button at any time in this process will

hang up the call (put it back 'on-hook').

• During a call, you can use the keypad to send DTMF

tones to the remote extension.

Cellphone Dial Mode

Enable Cellphone Operation Select Enable Cellphone Operation to put the Intercom

into Cellphone Dial Mode. In Cellphone Dial Mode, the

Intercom will operate like a cellular phone:

• This mode is similar to the telephone operation but you

dial in an extension differently.

• To make a call in this mode, dial the extension and then

press the call button to 'send' or initiate the call.

• Pressing the call button at any time in this process will

hang up the call (put it back 'on-hook').

• During a call you can use the keypad to send DTMF

tones to the remote extension.

Speed Dial Mode

Enable Speed Dial Select Enable Speed Dial to put the Intercom into Speed

Dial Mode. In this mode the user sets up extensions to

dial when a button is pressed.

The Speed Dial Timeout (in seconds) setting is the

number of seconds you need to hold the button before it

will place a call. If this value is 0, it will place a call as soon

as the button is released.

The speed dial fields in this mode will accept delayed

DTMF tones when a comma ',' is in the dial-out field.

Speed Dial Timeout (in seconds) Type the desired time (in seconds) that you want a button

held before it will initiate a call.

Note: A Speed Dial Timeout setting of 0 will start a call

as soon as the button is released.

Keypad (0 through 9, *, and #) Enter the desired dial-out extension number (64 character

limit).

Note: For information about dial-out extension strings and

DTMF tones, see

Section 2.3.6.1, "Dial Out Extension

Strings and DTMF Tones (using rfc2833)".

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 85 86

Kommentare zu diesen Handbüchern

Keine Kommentare

CyberData 011123x Spezifikationen Seite 42

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Türsprechanlagen CyberData 011123x